You can vary the size of the Unispense^® tubing assembly and the volume setting from 1 ml to 830 ml*. You can also change the delay between dispensings from 0.5 to 5 seconds. Keep the manual dispense button or footswitch depressed for continuous pumping. The single speed peristaltic pump accommodates liquids ranging in viscosity from aqueous solutions to medium syrups.

Unispense^® II records the number of doses from a ready reference. An audible signal at the end of the filling cycle frees you from visually monitoring the unit. There are no valves or pistons to become clogged or "frozen" so downtime is reduced. And, the used tubing assembly is removed and replaced with a fresh assembly in less than one minute.

When used with the Wheaton IV Additive Pump Chamber Assembly, Unispense^® II efficiently prepares IV Additive admixtures and fills sterile syringes for injectables.

*Depending on tubing used.

HI Volume I.V. Additive
Pump Chamber Assembly

Increase Production by Decreasing Filling Time

When used with the Wheaton Unispense^® II Automatic Dispenser, the Wheaton 6 mm I.D. HI Volume I.V. Additive Pump Chamber Assembly allows rapid transfer of I.V. Additive solutions to piggyback bottles and bags and sterile syringes for injectables.

The distal end of the Wheaton HI Volume I.V. Additive Pump Chamber Assembly is equipped with a vented spike and flexible drip chamber for use with bulk fill I.V bottles; the proximal end features a Luer lock fitting to which a beveled or vented needle can be attached.

The 6 mm I.D. silicone tubing increases productivity by reducing the time required to fill single dosages and is available as an individually packaged, disposable set, presterilized, and shipped ten sets per case.

Catalog Number WH374330
HI Volume I.V. Additive Pump Chamber Assembly
Case Pack 10

Call for further information or a free trial!